Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
110
Specify the value for switching the offset numbers in the following
system parameter:
No.704: 0 0 0 0 0 0 0 0
For each cutting area, the T code specifying tool
offset is:
= 0: Not output.
= 1: Output.
If the parameter is set to a value for outputting the T code specifying the
tool offset for each cutting area, the following prompt is displayed:
TOOL OFFSET NO. TM = Tool offset number for each. . . . . . .
cutting area
The cutting conditions and meanings of the system questions are
described below according to machining data.
(1)Center drilling
TOOL OFFSET NO. TM= Tool offset number (tool offset. .
number for each cutting area)
CLEARANCE C = Clearance quantity (mm). . . . . . .
(Default value is system parameter
No.180)
DEPTH OF CUT D = Depth of cut (mm). . . . .
SPINDLE SPEED N = Spindle speed (rpm). . . . .
FEED RATE F = Feedrate (mm/rev). . . . . . . . .

Leave a Reply

Your email address will not be published. Required fields are marked *