Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
111
(2)Drilling
Cutting conditions for drilling comprise type 1, 2 and 3 according to
the movement of a drill.
CUTTING CONDITIONS 1
TOOL OFFSET NO. TM= Tool offset number (Tool offset. .
number for each cutting area)
CLEARANCE. C = Clearance (mm or inch). . . . . . .
(Default value is system parameter
No.181)
CUT POINT. Z = Position of cut end point . . . . . . . . .
(mm or inch)
(When bit 7 of system parameter
No.702 is 1)
or
DEPTH OF CUT. D = Depth of cut (mm or inch). . . . .
(When bit 7 of system parameter
No.702 is 0)
SPINDLE ROTATION N = Spindle rotation speed (rpm).
FEED RATE F1 = Feed rate (mm/rev or inch/rev). . . . . . . . .
CUTTING CONDITIONS 2
TOOL OFFSET NO. TM= Tool offset number (tool offset. .
number for each cutting area)
CLEARANCE C = Clearance (mm or inch). . . . . . .
CUT POINT Z = Position of cut end point . . . . . . . . .
(mm or inch)
(When bit 7 of system parameter
No.702 is 1)
or
DEPTH OF CUT D = Depth of cut (mm or inch). . . . .
(When bit 7 of system parameter
No.702 is 0)
DEPTH OF CUT D1 = Primary drilling depth (mm or inch). . . . .
(Default value is system parameter
No.121)
RETURN AMOUNT U = Amount of return (mm or inch). .
SPINDLE ROTATION N = Spindle rotation speed (rpm).
FEED RATE F1 = Feed rate (mm/rev or inch/rev). . . . . . . . .

Leave a Reply

Your email address will not be published. Required fields are marked *