Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
112
CUTTING CONDITIONS 3
TOOL OFFSET NO. TM= Tool offset number (tool offset. .
number for each cutting area)
CLEARANCE C = Clearance (mm or inch). . . . . . .
CLEARANCE C1 = Secondary drilling dearance. . . . . . .
CUT POINT Z = Position of cut end point . . . . . . . . .
(mm or inch)
(When bit 7 of system parameter
No.702 is 1)
or
DEPTH OF CUT D = Depth of cut (mm or inch). . . . .
(When bit 7 of system parameter
No.702 is 0)
DEPTH OF CUT D1 = Primary drilling depth (mm or inch). . . . .
(Default value is system parameter
No.121)
DEPTH OF CUT D2 = Secondary drilling depth . . . . .
(mm or inch)
(Default value is system parameter
No.122)
RETURN AMOUNT U = Amount of return (mm or inch). .
SPINDLE ROTATION N = Spindle rotation speed (rpm).
FEED RATE F1 = Feed rate (mm/rev or inch/rev). . . . . . . . .
FEED RATE F2 = Feed rate for second pass. . . . . . . . .
(mm/rev or inch/rev)

Leave a Reply

Your email address will not be published. Required fields are marked *