Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
116
CUTTING SPEED V = Cutting speed . . . . . .
(m/min or feet/min)
FEED RATE F1 = Feedrate (mm/rev or inch/rev). . . . . . . . . . .
F2 = Feedrate (mm/rev or inch/rev)
F3 = Feedrate (mm/rev or inch/rev)
1ST OVERRIDE % = Displayed in case of outside. . . . . . .
diameter roughing.
Refer to the item (11).
* First override in outer surface roughing
In outer surface roughing, the depth and feedrate of the first cut can be
overridden. To specify the override, set bit 7 of system parameter
No.104 to 1
No.104: 0 0 0 0 0 0 x 0
Specifies whether the operator is prompted to
enter an override value.
= 0: Not prompted.
= 1: Prompted.
Even if the operator is not prompted to specify the override, the data can
be overridden by the value set in system parameter No.711.
No.711: Override value for the first cut in outer surface roughing
(10% to 100%)
Not defined: 100%
n: n%

Leave a Reply

Your email address will not be published. Required fields are marked *