Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
117
(7)Semi–finishing of outer figure
(8)Semi–finishing of inner figure
TOOL OFFSET NO. TM= Tool offset number (tool offset. . . .
number for each cutting area)
CLEARANCE CX= Clearance quantity in X–axis. . . . . . . . .
(mm or inch)
(Default value is system
parameter No.185)
CZ = Clearance quantity in Z–axis
(mm or inch)
(Default value is system
parameter No.186)
CZ2= Second clearance along the
Z–axis (mm or inch)
(The initial value is set in system
parameter No.194)
(Warning) (P.115)
FINISH ALLOWANCE TX = Finish allowance in X–axis . .
(mm or inch)
(Default value is system
parameter No.118)
TZ = Finish allowance in Z–axis
(mm or inch)
(Default value is system
parameter No.173)
CUTTING SPEED V = Cutting speed (m/min). . . . . .
FEED RATE F = Feedrate (mm/rev or inch/rev). . . . . . . . . . .
MAXIMUM RPM N = Maximum spindle speed. . . . . .
(Warning) (P.125)

Leave a Reply

Your email address will not be published. Required fields are marked *