Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
118
(9)Finishing of outer figure
(10)Finishing of inner figure
CLEARANCE CX = Clearance quantity in X–axis. . . . . . . . .
(mm or inch)
(Default value is system
parameter No.187)
CZ = Clearance quantity in Z–axis
(mm or inch)
(Default value is system
parameter No.188)
CZ2= Second clearance along the
Z–axis (mm or inch)
(The initial value is set in system
parameter No.194)
(Warning) (P.115)
CUTTING SPEED V = Cutting speed (m/min or. . . . . .
feet/min)
FEED RATE F1 = Feedrate
for (mm/rev or. . . . . . . . . . .
inch/rev)
F2 = Feedrate
for (mm/rev or
inch/rev)
F3 = Feedrate
for (mm/rev or
inch/rev)
F4 = Feedrate
for (mm/rev
or inch/rev)
MAXIMUM RPM N = Maximum spindle speed. . . . . .
WARNING
The prompt on the second clearance along the Zaxis can
be displayed.
The clearance becomes valid when the tool approaches the
workpiece during a process for inner surface machining. To
display the prompt, set the following system parameter:
No.702: 0 0 0 0 0 0 0 0
The second clearance specified for inner surface
machining becomes:
= 0: Invalid.
= 1: Valid.

Leave a Reply

Your email address will not be published. Required fields are marked *