Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
119
Turret turning
position
(11) Grooving/necking machining
[GROOVING/NECKING]
When a grooving tool is selected (TP = 3) (roughing type is 1)
TOOL OFFSET NO. TM = Tool offset number (tool offset. . . .
number for each cutting area)
TOOL OFFSET NO.2 TM2=Tool offset number 2 (tool offset. . .
number 2 for each cutting area)
FINISH TYPE TP2 =Type of finishing (1 or 2). . . . . . . . .
PECKING ON/OFF PE = Pecking . . . . .
(0: Not executed, 1: Executed)
CLEARANCE C = Clearance (mm or inch). . . . . . . . .
FINISH. ALLOWANCE TW = Finishing allowance for width. .
(mm or inch)
TB = Finishing allowance for depth
(mm or inch)
DEPTH OF CUT D = Depth of each cut in pecking . . . . . . .
(mm or inch)
RETURN AMOUNT U = Distance of each retraction in. . . .
pecking (mm or inch)

Leave a Reply

Your email address will not be published. Required fields are marked *