Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
121
DEPTH OF CUT D = Depth of each cut in pecking . . . . . . .
(mm or inch)
RETURN AMOUNT U = Distance of each retraction in. . . .
pecking (mm or inch)
CUTTING SPEED V = Cutting speed (m/min or. . . . . .
feet/min)
FEED RATE F1 = Approach feedrate in roughing. . . . . . . . . . .
(mm/rev or inch/rev)
MAX RPM N = Maximum spindle speed (rpm). . . . . . . . . . . .
When a versatile tool is selected
TOOL OFFSET NO. TM = Tool offset number (tool offset. . . .
number for each cutting area)
TOOL OFFSET NO.2 TM2=Tool offset number 2 (tool offset. . .
number 2 for each cutting area)
ROUGH TYPE TP1 =Type of roughing (1, 2, or 3). . . . . . . . .
CLEARANCE C = Clearance (mm or inch). . . . . . . . .
FINISH. ALLOWANCE TW = Finishing allowance for width. .
(mm or inch)
TB = Finishing allowance for depth
(mm or inch)
DEPTH OF CUT D = Depth of each cut in type 2 or 3 of. . . . . . .
roughing (mm or inch)
CUTTING SPEED V = Cutting speed (m/min or. . . . . .
feet/min)
FEED RATE F1 = Horizontal feedrate in roughing. . . . . . . . . . .
(mm/rev or inch/rev)
F2 = Approach feedrate in roughing
(mm/rev or inch/rev)
MAX RPM N = Maximum spindle speed (rpm). . . . . . . . . . . .
[FINISHING OF GROOVE]
When a grooving tool is selected
TOOL OFFSET NO. TM = Tool offset number (tool offset. . . .
number for each cutting area)
TOOL OFFSET NO.2 TM2=Tool offset number 2 (tool offset. . .
number 2 for each cutting area)
FINISH TYPE TP2 =Type of finishing (1 or 2). . . . . . . . .
CLEARANCE C = Clearance (mm or inch). . . . . . . . .
CUTTING SPEED V = Cutting speed (m/min or. . . . . .
feet/min)
FEED RATE F2 = Feedrate in finishing . . . . . . . . . . .
(mm/rev or inch/rev)
MAX RPM N = Maximum spindle speed (rpm). . . . . . . . . . . .
When a versatile tool is selected
FINISH TYPE TP2 =Type of finishing (1, 2, or 3). . . . . . . . .
CLEARANCE C = Clearance (mm or inch). . . . . . . . .
CUTTING SPEED V = Cutting speed (m/min or. . . . . .
feet/min)

Leave a Reply

Your email address will not be published. Required fields are marked *