Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
122
FEED RATE F3 = Feedrate in finishing . . . . . . . . . . .
(mm/rev or inch/rev)
MAX RPM N = Maximum spindle speed (rpm). . . . . . . . . . . .
The following figure shows the relationship between the clearance and
finishing allowance in grooving.
Roughing can be executed in the following three ways:
Finishing can be executed in the following three ways:

Leave a Reply

Your email address will not be published. Required fields are marked *