Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
124
If AC is set to 90 and AN is set to 90, the virtual tool tip is on the right
side of the tool.
A specified cutting area must not contain two or more grooves or cuts.
Divide the cutting area so that a single cutting area contains only one
groove or cut.
(12)Threading
CUTTING METHOD TP = 1 : Singleedge thread cutting with. .
constant cutting amount
2 : Bothedge zigzag thread cutting
with constant cutting amount
3 : Singleedge thread cutting with
constant cutting depth
4 : Bothedge zigzag thread cutting
with constant cutting depth
CLEARANCE CT = Clearance quantity (mm or inch). . . . . . .
(Default value is system parameter
No.190)
CS = Clearance quantity (mm or inch)
(Default value is system parameter
No.191)
CE = Clearance quantity (mm or inch)
(Default value is system parameter
No.192)
DEPTH OF CUT D = Depth of cut (mm or inch). . . . .
DL = Final depth of cut (mm or inch)
(Default value is system parameter
No.119)
CUTTING SPEED V = Cutting speed (m/min or feet/min). . . .

Leave a Reply

Your email address will not be published. Required fields are marked *