Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
126
CLEARANCE C1 = (mm or inch). . . . . . . . .
Specify the clearance from the
blank figure along the X–axis.
(The initial value is set in system
parameter 193.)
FINISH. ALLOWANCE TZ = (mm or inch). .
Specify the finishing allowance
for the workpiece subjected to
cutting off.
CUT OFF POS. CO = (mm or inch). . . . . . . .
Specify the distance between the
cut off point and the inner surface
or center of the workpiece.
(The initial value is set in system
parameter 141.)
COND. RESET POS. CR = (mm or inch). . . .
Specify the distance between the
point at which the cutting
conditions are changed and the
cut off point. (The initial value is
set in system parameter 142.)
RETURN AMOUNT RA = (mm or inch). . . .
Specify the retraction distance
along the Xaxis of the tool from
the point at which the cutting
conditions are changed.
(The initial value is set in system
parameter 143.)
CUTTING SPEED V1 = (m/min or feet/min). . . . . .
V2 = (m/min or feet/min)
FEED RATE F1 = (mm/rev or inch/rev). . . . . . . . . . .
F2 = (mm/rev or inch/rev)

Leave a Reply

Your email address will not be published. Required fields are marked *