Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
127
For the example of cutting off shown in Fig. 3.4.9 (a), specify the
cutting speed and feedrate from a to b and b to c with V1 and F1,
respectively. Then specify the cutting speed and feedrate from c to d
with V2 and F2 respectively.
Fig. 3.4.9 (a)
(14)BAR FEED
The bar feed is the distance from the end of the workpiece after cutting
off to the end of the workpiece defined by the blank figure. The system
automatically calculates the bar feed.
Fig. 3.4.9 (b)

Leave a Reply

Your email address will not be published. Required fields are marked *