Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
128
On the cutting conditions screen, the operator is first prompted to enter
the machining type.
TYPE BT =. . . . . .
Type 1: Pullout mode 1
Type 2: Pullout mode 2
Type 3: Slidestop mode 1
Type 4: Slidestop mode 2
The subsequent inquiries depend on the machining type specified.
1) Pull–out mode 1
CLEARANCE CAZ=Approach clearance (mm). . . .
(The initial value is set in system
parameter 153.)
GRIP POS. WG =Workpiece gripping position (mm). . . . . . .
(The initial value is set in system
parameter 154.)
ESCAPE VALUE CEZ=Distance the tool is retracted (mm). .
(The initial value is set in system
parameter 155.)
FEED RATE F1 = Feedrate (in gripping) (mm/min). . . . . .
F2 = Feedrate (in pulling and positioning)
(mm/min)
F3 = Feedrate (in retraction) (mm/min)

Leave a Reply

Your email address will not be published. Required fields are marked *