Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
129
2) Pull–out mode 2
CLEARANCE CAX=Approach clearance (mm). . . .
(The initial value is set in system
parameter 152.)
GRIP POS. WG =Workpiece gripping position (mm). . . . . . .
FEED RATE F1 = Feedrate (in gripping) (mm/min). . . . . .
F2 = Feedrate (in pulling and positioning)
(mm/min)
F3 = Feedrate (in retraction) (mm/min)
3) Slide–stop mode 1
CLEARANCE CAZ=Approach clearance (mm or inch). . . .
ESCAPE VALUE CEZ=Distance the tool is retracted . .
(mm or inch)
RPM S1 = Spindle speed (rpm). . . . . . . . . . . .
(The initial value is set in system
parameter 156.)
FEED RATE F2 = Feedrate (for sliding) (mm/min). . . . . .

Leave a Reply

Your email address will not be published. Required fields are marked *