Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
131
If 1 is entered, the CUTTING AREA screen is displayed to enable
specification of the desired area. If 0 is entered, the process directory
screen displaying prompts relating to the next machining is displayed.
The tool data and tooling information can be set and all the tooling
information can be deleted on the machining process list (shown in
machining definition) or the tool data setting screen of a process.
[Machining process list]
To set the tool data and tooling information on the machining process list,
press the rightmost soft key [
]. The following soft keys are then
displayed.
If either of the following soft keys is pressed, the corresponding data list
screen is displayed:
TOOL DATA : The tool data list is displayed.
TOLING INFOR. : The tooling information list is displayed.
[Tool data setting screen]
3.4.10
Setting the Tool Data
and Tooling
Information

Leave a Reply

Your email address will not be published. Required fields are marked *