Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
135
In machining definition, a blank figure can be painted and a cutting area
can be drawn (line drawing) on the screen for setting an area or machining
conditions. Set the following system parameters as shown below:
No.704: x x 0 0 0 0 0 0
0: The blank figure is not painted.
1: The blank figure is painted.
0: The cutting area is not drawn.
1: The cutting area is drawn.
No.670: Color in which the blank figure is filled in (0 to 7)
No.671: Color of the line which draws the cutting area (0 to 7)
NOTE
The system parameters are valid only for turning.
(1)Drawing a cutting area (line drawing)
When bit 7 of system parameter 704 is set to 1, the cutting area is drawn
on the cutting area definition screen and cutting condition setting
screen, as shown below:
1) Drawing the area on the cutting area screen
D Each time the start point, end point, or dividing direction is
changed, the drawing is changed accordingly.
D The area for which the tool angle is not checked is drawn.
2) Drawing the area on the cutting condition screen
D Each time the finishing allowance is changed, the drawing is
changed accordingly.
D The area for which the tool angle is checked is drawn.
3.4.11
Drawing a Cutting Area
and Painting a Blank
Figure

Leave a Reply

Your email address will not be published. Required fields are marked *