Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
136
(2)Painting the blank figure
When bit 6 of parameter 704 is set to 1, the blank figure is filled in on
the cutting area definition screen and cutting condition setting screen
as shown below:
NOTE
In 16TC CAP II, 16iTA CAP II, and Symbol CAPi T, a
blank figure cannot be Painted on the cutting area definition
screen or cutting condition screen.

Leave a Reply

Your email address will not be published. Required fields are marked *