Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
138
Soft keys are displayed as shown below.
(1)Setting of 1path lathe (MTF1050=1) with the animated simulation
option
(2)Setting of 2path lathe (MTF1050=2) without the animated
simulation option or Series 16–TTA
The above soft keys are displayed, and the following message prompts
you to input a program No. and comment.
PROGRAM No. Input 0 = program No.. . . . . . . . .
COMMENT Input CM = comment.. . . . . . . . . . . .
Comments are specified in alphanumerics or symbols of 16 characters or
less.
If 17 or more characters are input, only the first 16 will be valid. All keys
other than round brackets, inverted commas and commas (“,”) can be
used.
Example) When 0 = 1234
, CM = ABCD is input,
0 1 2 3 4 (ABCD);
is registered in the machining memory.
If system parameter No.708 bit 2 is set to 1, the process name comment
will be added automatically and output to the head of each process.
#7
708
#6 #5 #4 #3 #2 #1 #0
Bit 2 Process name comment during NC format output:
0 : not output
1 : automatically output
Example) The OD roughing process head NC format when system
parameter No.708 bit 2 =1 is:
(ROUGH. OF. OUT.)
N002 GOTO202;
...
...

Leave a Reply

Your email address will not be published. Required fields are marked *