Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
140
[ANIMATION]
or [ANIMATION]
This key determines whether or not to perform background animated
simulation while NC data are being generated.
Each time this key is touched, the setting alternates between
[ANIMATION]
and [ANIMATION].
Blank figures and part figures are drawn in the
[ANIMATION]
state.
Blank figures are drawn in colored backgrounds. Machining is
simulated during NC data preparation.
Animated simulation performed in this state is called
[BACKGROUND ANIMATION] and is distinguished from animated
simulation specified on Menu No.6.
(Animated simulation Specified on Menu No.6 is called
[FOREGROUND ANIMATION].)
Part figures alone are drawn in the [ANIMATION] state.
Tool paths are displayed during NC data preparation.
[TOOL PATH]
or [TOOL PATH]
This key appears only in the
[ANIMATION]
state.
Each time this key is pressed, the setting alternates between
[TOOL PATH]
and [TOOL PATH].
In the
[TOOL PATH]
state, the path of the virtual tool position is
always displayed in purple.
No path is displayed in the [TOOL PATH] state.
[SINGLE STEP]
or [SINGLE STEP]
Each time this key is pressed, the setting alternates between
[SINGLE STEP]
and [SINGLE STEP].
NC data is output continuously in the
[SINGLE STEP]
state. (Refer
to Chapter VIII 1.4 NC Data Output by Single Step”.)
[PROC. STOP]
or [PROC. STOP]
Each time this key is pressed, the setting alternates between
[PROC. STOP]
and [PROC. STOP].
In the
[PROC. STOP]
state, NC data output is suspended
temporarily at the specified position of each process.
The half position is set by system parameters No.49 to No.57 and
No.310 to No.314. (Refer to Chapter VIII 1.4 Single Step Output.)
[NC DATA]
or [NC DATA]
Each time this key is pressed, the setting alternates between
[NC DATA]
and [NC DATA].
NC data is displayed in the
[NC DATA]
state.
No NC data is displayed in the [NC DATA] state.

Leave a Reply

Your email address will not be published. Required fields are marked *