Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
142
After NC data is automatically created, ***PRESS SOFT KEY*** is
displayed at the screen bottom.
When PROCESS LIST is pressed then, a list indecating the machine
time for each process and the total machining time is displayed.
PROCESS LIST
These machining time are the theoretical values figured out when NC data
was automatically created. The machining time is of course changed if
feed rate override is effected in actual machining.
NOTE
When over 20 processes are defined, a bar graph is not
displayed.
WARNING
After process editing, check the editing results. If edits are
made incorrectly, the tool may collide with the workpiece
and/or machine, or forced machining may occur, possibly
causing damage to the workpiece, machine and/or tool
itself, or injury to the user.
(1)Summary
In the initial screen of Menu 5, NC DATA PREPARATION, the
operation sequence defined in Menu 4, MACHINING DEFINITION
is displayed for each turret. Further it is possible to edit the S Code and
operation sequence on this screen.
In editing the S code, a surface speed defined with “MACHINING
DEFINITION” can be reindicated with an other value.
3.5.3
Display of Machining
Time
3.5.4
Process Editing
Function (Only with
2–path Control)

Leave a Reply

Your email address will not be published. Required fields are marked *