Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
143
In editing the operation sequence, each operation can be arranged by
shifting up or down the operation sequence independently for each turret
and a simultaneous operation by using both turrets is possible. When this
function is used, M code for waiting is output automatically for use in
preparation of the NC program.
In Menu 4, MACHINING DEFINITION suppose we define the
following operation sequence,
Process No. Kind of Machining Turret No.
1 Drilling 1
2 Roughing of outer figure 1
3 Roughing of inner figure 2
4 Finishing of outer figure 1
5 Finishing of inner figure 2
6 Grooving (External) 1
7 Grooving (Internal) 2
8 Threading (External) 1
9 Threading (Internal) 2
Namely, suppose we define the cutting operation sequence:
1. Drilling with a tool on the turret 1
2. Roughing of outer figure with a tool on the turret 1
3. Roughing of inner figure with a tool on the turret 2
4. Finishing of outer figure with a tool on the turret 1
5. Finishing of inner figure with a tool on the turret 2
6. Grooving with a tool on the turret 1 (External)
7. Grooving with a tool on the turret 2 (Internal)
8. Threading with a tool on the turret 1 (External)
9. Threading with a tool on the turret 2 (Internal)
in order.
When such cutting definition is executed, the following operation
procedure in displayed on the initial screen of Menu 5, NC DATA
PREPARATION.

Leave a Reply

Your email address will not be published. Required fields are marked *