Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
144
Thus, cutting operations for each turret are displayed. For the section on
spindle speed, “N” means spindle speed, “V” means cutting speed. For
simultaneous operation; No.2 and 3, ROUGHING OF OUTER
FIGURE” and ROUGHING OF INNER FIGURE, operation No.8 and
9, “THREADING” and “DOWN” (or set the cursor to No.3 and depress
HEAD 2 UP), and then set the cursor to No.8 and depress the soft key,
HEAD 1 DOWN (or set the cursor to No.9 and depress HEAD 2 UP”)
continuously. For changing the cutting speed of operation No.6,
“GROOVING”, 125 m/min for instance, set the cursor to No.6 and input
125 through keys for the question, V (N) =. When performing such
operations, the operation procedure is displayed as follows.
As for S code, an A code is output from either turret 1 or turret 2 when
a simultaneous operation is executed. Which turret is used can be
recognized by the speed indication on the upper screen. Whenever the
soft key, S CODE SELECT is depressed the value of turret 1 and 2 is
alternately displayed.
(2)SOFT KEY
The meaning of soft keys is as follows:
[ESCAPE] Processing of this screen is discontinued.. . . . . . . . . . .
[HEAD 1 UP] Allow the operation sequence of the turret. . . . . . . .
1 located with the cursor to go up by one
step.
[HEAD 1 DOWN] Allow the operation sequence of the turret. . . .
1 located with the cursor to go down by one
step.
[HEAD 2 UP] Allow the operation sequence of the turret. . . . . . . .
2 located with the cursor to go up by one
step.
[HEAD 2 DOWN] Allow the operation sequence of the turret. . . .
2 located with the cursor to go down by one
step.
[S CODE SELECT] When under simultaneous operation, select. . .
the turret for which the S Code has priority.
[CURSOR °] Move the cursor position backward.. . . . . . . . .
[CURSOR ±] Move the cursor position forward.. . . . . . . . .
[NEXT PAGE] Advance to the next screen (screen inquires. . . . . . .
details of the program number.)

Leave a Reply

Your email address will not be published. Required fields are marked *