Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
145
(3)Edition of the operation sequence
As explained in paragraph Soft key, the operation sequence can be
shifted upward or downward by depressing HEAD 1 UP”, “HEAD
1 DOWN”, “HEAD 2 UP and HEAD 2 DOWN, however, to shift
the operation sequence by this handling is possible during only one
step per operation. Shifting for two steps is not possible. The
operation sequence of turret 1 cannot be transferred to turret 2.
NO HEAD 1 HEAD 2 SPEED
1
ROUGHING OF
OUTER FIGURE.
G96V145M03 (1)
2
ROUGHING OF
INNER FIGURE.
G96V150M03 (2)
3
FINISHING OF
OUTER FIGURE.
G96V200M03 (1)
4
GROOVING G96V100M03 (1)
5
GROOVING
G96V120M03 (2)
If the process editing is executed for the simultaneous
operation of processes 1 and 2, and 4 and 5 the operation is
performed as follows:
NO HEAD 1 HEAD 2 SPEED
1
ROUGHING OF
OUTER FIGURE.
ROUGHING OF
INNER FIGURE.
G97V145M03 (1)
2
3
FINISHING OF
OUTER FIGURE.
G97V200M03 (1)
4
GROOVING
GROOVING
G97V120M03 (2)
5
CAUTION
1 When G96 mode process and G97 mode process are
simultaneously instructed, G97 mode process has priority.
2 If two G96 modes are simultaneously specified, the control
changes to the G97 mode process.
The spindle is controlled by the turret 1 side, but it is
controlled by the turret 2 side when the S CODE SELECT
soft key is pressed.
(Example)

Leave a Reply

Your email address will not be published. Required fields are marked *