Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
148
(1)Overview
When a model having two turrets is used, the program of turret 1 or
2 contains only the NC data of processes which corresponds to the
turret specified in machining definition. If outer surface roughing is
programmed for turret 1 and inner surface roughing is programmed for
turret 2, for example, the programs are output as shown below:
Turret 1
O0001;
M100;
M101;
M05;
M30;
%
NC data of
outer surface
roughing
Turret 2
O0002;
M100;
M101;
M05;
M30;
%
NC data of
inner surface
roughing
The program for turret 2 does not contain the block corresponding to outer
surface roughing of turret 1.
The program for turret 1 does not contain the block corresponding to inner
surface roughing of turret 2.
A machine may require that the programs of the two turrets share NC data
(such as M01) as shown below.
Turret 1
O0001;
M100;
M101;
M05;
M30;
%
NC data of
outer surface
roughing
Turret 2
O0002;
M100;
M101;
M05;
M30;
%
NC data of
inner surface
roughing
M01;
M01;
M01;
M01;
This can be done by setting a function code to output M01; in MTF2045.
MTF2045 specifies the special block to be output to the programs of both
turrets at the end of each process.
3.5.5
Special Block Output
to both Programs

Leave a Reply

Your email address will not be published. Required fields are marked *