Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
149
(2)Examples of setting and output
When the following machining is programmed, the programs are
output as shown below:
Turret 1
Outer surface
roughing
Process 1
Process 2
Outer surface
finishing
Process 3
Inner surface
roughing
Inner surface
finishing
Turret 2
Turret 1 only. . . . . . . . .
Turret 2 only. . . . . . . . .
Simultaneous. . . . . . . . .
operation of
turrets 1 and 2
1) Example 1 for setting MTF
MTF2011 (End of roughing process)
MTF2013 (End of finishing process)
0003, 0004, 0000, 0000, 0000, 0000,
Txx00 ;
MTF2045 (Special block)
0605, 0004, 0000, 0000, 0000, 0000,
M01 ;
0000, 0000, 0000, 0000,
(3)NC data output for one tool post only
If an outer surface rough machining process is defined only for tool
post 1, for example, corresponding NC data is output as described
below:
The wait M code is output immediately before the end of the program
(MTF function table No. 2001).
NC data for tool post 1 NC data for tool post 2
0XXXX ; 0**** ;
Outer surface rough machining NC data
TXX00 ;
M01 ;
M100 ; ² Wait M code output ³ M100 ;
M05 ; ² End of the program (2001) ³ M06 ;
M30 ; M30 ;
%%
NOTE
The number enclosed in parentheses is the MTF function
table number.
The wait M code output in the above example is the wait M
code initial value (system parameter No. 730).

Leave a Reply

Your email address will not be published. Required fields are marked *