Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
152
(3)Warning and Notes
WARNING
1 The special code of an auxiliary machining process is not
output to the programs of the two turrets.
The first sequence number of a process is output to the
program of the turret on which the corresponding process
is not executed.
2 In the programs of the two turrets, identical processes may
have different sequence numbers at the beginning.
For example, while the sequence number at the beginning
of process 1 is N2 in the program of turret 1, the
corresponding sequence number may be N1 in the program
of turret 2.
3 If processes are edited on the process edit screen so that
auxiliary machining and other processes are
simultaneously executed on the two turrets, the total
number of special codes in the NC data of the two turrets
may differ.
NOTE
The function to output the MTF2045 block is provided only
for a lathe having two turrets. When MTF1050 is set to 1 (a
lathe having only one turret is used), the block is not output.
1. Overview
If the NC data for threading are created on a 15TFB or 16T CAP II,
the threading path is generally created with G92. Depending on the
setting of MTF, the NC data for G76 (multiple thread cutting cycle)
can also be created.
Fig. 3.5.6 Cutting condition screen
3.5.6
Outputting the NC Data
of a Multiple Thread
Cutting Cycle

Leave a Reply

Your email address will not be published. Required fields are marked *