Fanuc Symbol CAPi T Operators Manual

The threading path is repeated.
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
153
If the multiple thread cutting cycle is used, the 16T CAP II dis-
plays a prompt relating to the depth of cut (DL). The 15TFB dis-
plays no prompts about DL.
Soft keys
[ESCAPE]: Returns to the FAPT menu screen.
[BACK PAGE]: Returns to the previous page.
[CURSOR °] or [CURSOR ±]: Moves the cursor up or down through the
prompts.
[DRAWING RANGE]: Enlarges or reduces the drawing.
[NEXT PAGE]: Displays the next page.
Threading methods
Threading method 1: Cutting using one cutting edge and a constant
cutting amount
Threading method 2: Alternate cutting using two cutting edges and
a constant cutting amount
Threading method 3: Cutting using one cutting edge and a constant
depth of cut
Threading method 4: Alternate cutting using two cutting edges and
a constant depth of cut
If the multiple thread cutting cycle (G76) is used with the 16–T
CAP II, the prompt relating to the threading method is not dis-
played.
[Conventional NC data]
.
.
(THREAD.)
N002G50X100.Z100.;
G0T0101;
G97S0474M3;
Z2.71;
X64.;
G92X59.45Z–22.F2.;
G0Z2.645;
G92X54.222Z–22.;
G0Z2.594;
.
.

Leave a Reply

Your email address will not be published. Required fields are marked *