Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
157
(6)Setting function codes
High–order
three digits,
detail
Low–order
three digits,
general
category
Function
E 1 0 1 Outputs the address specified in MTF1392.
Thread radius (15TFB: I code)
Thread radius (16T CAP II: R code)
E 2 0 1 Outputs the address specified in MTF1393.
Thread height (15TFB: K code)
Thread height (16T CAP II: P code)
E 3 0 1 Outputs the address specified in MTF1394.
Depth of the first cut (15TFB: D code)
Depth of the first cut (16T CAP II: Q code)
E 4 0 1 Outputs the address specified in MTF1397.
Finishing allowance (15TFB: Invalid)
Finishing allowance (16T CAP II: R code)
E D 0 3 Outputs the address specified in MTF1395.
Tool angle (15TFB: A code)
Tool angle (16T CAP II: Invalid)
E E 0 3 Outputs the address specified in MTF1395.
Tool angle (15TFB: Invalid)
Tool angle + multiple parameters
(16T CAP II: P code)
E F 0 3 Outputs the address specified in MTF1396.
Specified cut method (15TFB: P code)
Specified cut method (16T CAP II: Invalid)
(7)Setting system parameters
No. Format
Initial
value
Description Remarks
230 Integer 1 Number of times final
finishing is repeated (1 to 99)
Valid only for the
FANUC Series 16
231 Integer 0 Coefficient of incomplete
thread (00 to 99)
Valid only for the
FANUC Series 16

Leave a Reply

Your email address will not be published. Required fields are marked *