Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
158
(8)Setting other data
This function causes no addition to, or modification of, the setting of
the material data and tooling information.
*** The threading methods that can be used depend on the NC
specifications. ***
15–TFB 16–T CAP II
(Threading method 1)
Cutting using one cutting edge and a
constant cutting amount
f f
G92
(Threading method 2)
Alternate cutting using two cutting edges
and a constant cutting amount
f f
G92
G32
(Threading method 3)
Cutting using one cutting edge and a
constant depth of cut
f f
(Threading method 4)
Alternate cutting using two cutting edges
and a constant depth of cut
f f
(Threading method 1)
Cutting using one cutting edge and a
constant cutting amount
f f
(Threading method 2)
Alternate cutting using two cutting edges
and a constant cutting amount
f
G76
(Threading method 3)
Cutting using one cutting edge and a
constant depth of cut
f
(Threading method 4)
Alternate cutting using two cutting edges
and a constant depth of cut
f

Leave a Reply

Your email address will not be published. Required fields are marked *