Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
162
NOTE
When the value of system parameter 750 is 1, the blank
drawing will be scaled to a magnification so that it will cover
nearly all of the display. If this scale needs to be changed,
it can be changed to various sizes of the drawing.
For data of the blank drawing, use data of L and D input with the key of
Menu 1, BLANK & PART (DRAWING & BLANK)”.
The following procedure is used for the animated simulation:
(1)Prepare conditions on the machine side
1) Set the coordinate system so that the work coordinates of the tool
may meet its current coordinates at the start of the program or move
the tool to the starting point of a program.
2) Execute the heading of the NC program.
3) Set to Machine Lock Mode.
(2)Press the CHECK START key among the soft keys. “START” will
then be indicated in the lower right section of the screen.
(3)Put the machine in NC operation
When a T Code is given, the tool drawing is represented and the
situation of the blank being cut can be visually observed.
In the case of clash between tool and chuck, or tool and tailstock the
interference check functions as an alarm, and then the situation is
displayed on the screen. For 2path lathe the interference alarm is
generated in the case of clash between tool and tool.

Leave a Reply

Your email address will not be published. Required fields are marked *