Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
164
When the vertical lathe is selected, turret 1 is shown to the right of the
workpiece.
Press [PARAMETER]
(1)CHUCK NO.
Up to 21 chuck figures can be registered (No.116 is the standard
figure, No.2125 is the special figure). This item select which chuck
of them is drawn.
(2)DEPTH OF CHUCKING, XPOSITION OF CHUCK
This data is for fixing the chuck drawing position. When the chuck
is an outer or inner claw one, and the blank figure is a round rod or
hollow round rod, the chuck drawing position is determined only by
DEPTH OF CHUCKING. In other cases (When the chuck is a
special one or the blank figure is special), the chuck drawing position
is determined by both DEPTH OF CHUCKING and
“X–POSITION OF CHUCK”.
3.6.4
Setting of Parameters
for Animated
Simulation

Leave a Reply

Your email address will not be published. Required fields are marked *