Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
165
Example 1) For outer claw check and round rod
Example 2) For special chuck
(3)TAILSTOCK NO.
Up to 7 types of tailstocks can be registered (1 and 2 indicate the
standard figures, while 11 to 15 indicate special figures). This is used
to indicate which tailstock is drawn.
(4)POSITION OF TAILSTOCK
This data is used to set the drawing position of tailstock. Input the
distance from the work zero point.
a) In the case of standard tailstock:
b) In the case of special tailstock:
The figure is specified by point data. Drawing is made so that the
distance between the point data “0” and work zero point is equal
to ZT.
NOTE
Be careful since simulation of the machining state may not
be conducted accurately if an excessively wide scale is
adoped.

Leave a Reply

Your email address will not be published. Required fields are marked *