Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
166
[MENU SCREEN] Return to the main menu screen.. . . .
[CHUCK] Screen for setting chuck figure appears.. . . . . . . . . . .
[TAILSTOCK] Screen for setting tailstock figure appears.. . . . . . .
[TOOL HOLDER] Screen for setting tool holder figure. . . .
appears.
[CURSOR °] [CURSOR ±] Press this to select the question. .
items.
[END] Return to the previous screen (animation. . . . . . . . . . . . . .
drawing screen here).
(5)Gradation animated simulation
In the 16TC CAP II, 16iTA CAP II, and Symbol CAPi T, the
GRADATION GD= prompt on the animated simulation parameter
setting screen requests the operator to specify whether to use gradation
drawing in animated simulation (initially, no gradation drawing is
selected). See Part XIII, Animated Simulation Function II, for
detail.
[CHUCK]
There are two types of chuck figures, namely standard figure and special
figure.
Up to 16 standard figures and up to 5 special figures can be registered.
The numbers 116 and 2125 are assigned to the standard figure and
special figure, respectively.
(1)Setting of standard figure
Set the data L, W, L1, and W1 by referring to the illustration diagram
on the screen.
When the cursor is at the “TYPE” position, either “OUT” or “IN” is
displayed.
Press either software key to select type.
[MENU SCREEN] Return to the main menu screen.. . . .
[UNDEFINE] Let the data where a cursor exists to an. . . . . . . .
undefined one.
[NO. ±] The cursor moves to the start of next line.. . . . . . . . . . . . .
3.6.5
Setting of Chuck
Figure

Leave a Reply

Your email address will not be published. Required fields are marked *