Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
167
(2)Setting of special figure
When either value of 2125 is input while the cursor is at the “NO”
position, the screen for setting the chuck data of special figure appears.
Designate the special chuck figure with 16 points. With P1 as the starting
point, connect the values set to P2, P3 – – in sequence, using a line for
drawing. When the control asks End Point P =, input the final point of
the figure data. The point data after the end point number is not regarded
as the figure forming data.
[CHECK] Draws a pattern, based on the input figure data.. . .
[ERASE] Erases the drawn pattern.. . . .
At the parameter setting screen for animated simulation
[TAILSTOCK]
There are two types of tailstocks as in chuck, namely standard and special
figures. Up to 2 special figures and up to 5 special figures can be
registered.
The numbers 12 and 1115 are assigned to the standard figure and
special figure, respectively.
3.6.6
Setting of Tailstock
Figure

Leave a Reply

Your email address will not be published. Required fields are marked *