Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
168
1) Setting of standard figure
Set the data D, D1, D2, D3, L, L1, and L2 by referring to the
illustration diagram on the screen.
[MENU SCREEN] Return to the main menu screen.. . . .
[UNDEFINE] Let the data where a cursor exists to an. . . . . . . .
undefined one.
[NO. ±] The cursor moves to the start of next line.. . . . . . . . . . . . .
2) Setting of special figure
When either value of 1115 is input while the cursor is at the “NO”
position, the screen for setting the tailstock figure of special figure
appears.
As with special chuck profile designation, the profile is determined by
the point indication to within 16 points. Set P1 as the starting point
and set points P2, P3, ... in order and the profile is connected by lines
to these points.
Concerning the question, END POINT P = input the final point of
the profile data. Point data described in the following numbers are not
regarded as profile data.
[CHECK] A figure is drawn based on the input profile data.. . .
[ERASE] A drawn figure is erased.. . . .
In the parameter setting screen for animated simulation
[TOOL HOLDER]
The tool holder number directry screen appears. Up to 32 tool holders can
be set.
[MENU SCREEN] Return to the main menu screen.. . . .
[SET DATA] This is a software key for setting figure data.. . . . . . . . .
Move the cursor to the number to be set and
then press this key.
[CURSOR °] [CURSOR ±] Press this key to select the number to. .
be set.
[END] Return to the previous screen (parameter. . . . . . . . . . . . . .
screen for animated simulation).
3.6.7
Setting of Tool Holder
Figure

Leave a Reply

Your email address will not be published. Required fields are marked *