Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
169
[SET DATA]
The tool profile is divided into the tip section and holder section. Input
the holder profile data onto this screen. The setting procedure is
performed with the point indication the same as for chuck and tailstock.
Up to a maximum points of 16 points and used.
(Example) Data in order to draw the holder profile as shown in the
following figure is:
P1
X = 0
Z = 0
P2
X = 10.
Z = 5.
P3
X = 200.
Z = 5.
P4
X = 200.
Z = 200.
P5
X = 30.
Z = 200.
P6
X = 30
Z = 30
P7
X = 10.
Z = 50.
P8 to P16
No relation
END POINT P = 7
Press [CHECK]

Leave a Reply

Your email address will not be published. Required fields are marked *