Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
171
#7
701
#6 #5 #4 #3 #2 #1 #0
Bit 2 In case of 1, continue drawing even if an interference alarm occurs.
Bit 3 In case of 1, animated drawing cutting simulation will operate even in
Manual Mode.
Bit 4 In case of 1, a center line is not drawn.
Bit 5 In case of 1, the interference check is not executed.
Bit 6 In case of 1, blank figure is redrawn when M30 is executed.
Bit 7 In case of 1, setting the parameter for animation drawing is prohibited.
750 Drawing scale factor
When the value is 1, the blank drawing is enlarged so that it will
almost completely cover the CRT display.
Numbers, 751 through 754 are the parameters which indicate the size of
the tool tip when drawn on. (L: parameter value)
751 Parameter for Drill Tools
In case of the tip angle is 180°
752 Parameter for Grooving and Side Tools
753 Parameter for Threadcutting Tools
3.6.9
Related System
Parameters

Leave a Reply

Your email address will not be published. Required fields are marked *