Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
173
(c) Special chuck, special tool stock, special holder
N6001 L*0**
E ; P X
1
; P Z
1
; .............
No.
1:
2: Tailstock
3: Holder
End point
(3)Error message
(a) I/O NOT READY
This message is displayed when an input or output device is not
ready for operation.
(b)TV ERROR INCLUDING
When a block, in which the number of characters is an add, is used,
this message is displayed.
(c) ILLEGAL FORMAT DATA DETECTED
When a block other than a format described in (2), is used or when
a block other than that to be expected is used, this message is
displayed.
NOTE
1 When the chuck data is input, data is notreplaced. But,
chuck data now being registered is initialized and input data
is newly registered.
2 Data are not output at points larger than end data in the I/O
of special chuck, special tail stock and holder data.
Even if a block number exceeding the maximum point data
is entered, the data is neglected without processing it as an
alarm.

Leave a Reply

Your email address will not be published. Required fields are marked *