Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
4. SUB CYCLE FUNCTION
PROGRAMMING AND
OPERATION BY Symbolic FAPT
177
(Soft keys)
[CURSOR °] [CURSOR ±] These keys are used to select the. .
menu number.
[END] This key is depressed when the sub cycle file has been. . .
created. The display returns to the family program
screen.
(3)Sub cycle detail setting pattern
The display shifts to the following screen when the sub cycle name is
set.
Set the calling G code, the program number, the address and the
comment of the required argument on this screen.
The G code must always be set. “KEY–IN AGAIN is displayed if it
is tried to return to the menu screen without defining G code.
The program number should be left undefined if the correspondence
between the calling G code and the called program number is set by
a parameter on the NC side.
Up to 10 arguments are settable. Also the comment is settable in up
to 6 characters. The arguments can be programmed by any addresses
excluding G, L, N, O, and P. For I, J, and K only, they must be
programmed in alphabetical order.
(Soft keys)
[CURSOR °] [CURSOR ±] These keys are used to select the. .
question to be set. Such a method of
feeding as to leave the address
undefined and to define the comment
only is impossible.
[END] This key is depressed when all the settings are over. The. . .
display returns to the preceding sub cycle menu screen.

Leave a Reply

Your email address will not be published. Required fields are marked *