Fanuc Symbol CAPi T Operators Manual

Roughing of outer figure
Insert movement statements
PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
4. SUB CYCLE FUNCTION
186
(Example 3)
If the same sub cycle as in Example 1 is defined in the following order
of processes:
Process 01 Sub cycle
Process 02 Roughing of outer figure
the following NC data is output:
%
O0001;
N0003 G65 P1000 L2 A25.65 B12.5 C8.23
;
N0002 G50 X0. Z180. S2000;
G00 T0101;
.
.
.
T0100;
M01;
X200. Z380.;
M05;
M30;
%
(Example 4)
The modal call should be made in the following order:
1) Define the sub cycle in the definition of machining, and select
pattern number 2 (G66ROUGH).
2) Then define the sub cycle in the next process, and select pattern
number 3 (G67). The repetition count is asked in the sub cycle data
screen. Depress the soft key NEXT PAGE by leaving the asked
repetition count undefined.
3) Insert movement statements by outputting menu 5 NC DATA
PREPARATION” in a single step.
%
O0001;
N0001 G66 P2000 A__ B__ ;
Z100.;
X100.;
.
.
.
Z200.;
G67;
M05;
M03;
%

Leave a Reply

Your email address will not be published. Required fields are marked *