Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
5. EXTENDED SUB
CYCLE FUNCTION
190
Regarding how a sub cycle is output on a NC part program, refer to
chapter III. PROGRAMMING AND OPERATION BY Symbolic FAPT,
section 4.5 Output of NC Data, of the CONVERSATIONAL
AUTOMATIC PROGRAMMING FUNCTION FOR LATHE,
OPERATOR’s MANUAL, B–61804E–2/04.
Maximum number of arguments, output on NC part program, is up to 33.
5.2
HOW A SUB CYCLE
IS OUTPUT ON NC
PART PROGRAM

Leave a Reply

Your email address will not be published. Required fields are marked *