Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
6. BALANCE CUT FAPT FUNCTION
(2PATH LATHE ONLY)
PROGRAMMING AND
OPERATION BY Symbolic FAPT
199
NOTE
1 When type B is selected, the M code set at MTF1040
(override cancel ON) is output.
2 When type B is selected, the M code set at MTF1041
(override cancel OFF) is output.
3 When type B is selected, the initial value of a waiting M code
is set using system parameter No. 735.
4 The delay time of the tool on head 2 is calculated based
upon the delay amount (DA) and the surface speed.
5 Balance cut (type A) start G code.
6 Balance cut (type A) end G code.

Leave a Reply

Your email address will not be published. Required fields are marked *