Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
6. BALANCE CUT FAPT FUNCTION
(2–PATH LATHE ONLY)
200
(1)System parameter
No.707, 735, and No.757 are related. Refer to the concerned sections
for the meaning of these parameters.
(2)MTF
(1)No.1140: M code for turning on override cancel (for type B)
This code is not output when 1 is set.
(2)No.1141: M code for turning off override cancel (for type B)
This code is not output when 1 is set.
Whether to exercise constant surface speed control for the balance cut B
function depends on the setting made for system parameter No. 707.
When constant surface speed control is exercised, a waiting M code is
output at the cut point; in addition, a turret waiting M code is output at the
position to which the tool is retracted, by the return escape amount, from
the end point of the cutting path.
6.6
RELATED
PARAMETERS
6.7
CONSTANT
SURFACE SPEED
CONTROL FOR
BALANCE CUT B

Leave a Reply

Your email address will not be published. Required fields are marked *