Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
6. BALANCE CUT FAPT FUNCTION
(2PATH LATHE ONLY)
PROGRAMMING AND
OPERATION BY Symbolic FAPT
201
Be careful of the following when using type B balance cut.
CAUTION
When the delay amount (DA) is too large, machining of the
second tool may not complete while the first tool is moving
to the next machining position (indicated by the dotted line
in the figure below). In this case, a new S code is output for
the next machining of the first tool.
This may affect the machining of the second tool.
New S code output
Path of the first tool
Path of the second tool
NOTE
1 When there are two or more pocket areas, balance cutting
is not performed from the second pocket.
Balance cutting is performed by head 1 and 2 tools in the
first pocket.
In the second pocket and after, only the tool on head 1 is
used for machining.
2 During pocket machining, the second tool may follow the
path of the first tool.
Balance cut of type B is
not performed.
Balance cut of type B is
performed.
Path of the first tool
Path of the second tool
6.8
CAUTION AND
NOTES

Leave a Reply

Your email address will not be published. Required fields are marked *