Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
2. INPUT/OUTPUT AND
COLLATION OF DATA
VARIOUS FILE AND DATA
219
The above data are output (registered) to the submemory by displaying
the setting screen of each data and pressing the [SAVE END] soft key.
Input from the submemory is done without any operation, because it is
automatically load to the main memory when power is turned on.
NOTE
How to display the setting screen of each data is explained
later.
In the screen displaying xxx INPUT (calling) or xxx OUTPUT”,
registering key in,
No. = Numeral, C
INPUT
to the question NO. =”.
(The “, C can be omitted. See (Note 1).)
EF = will be questioned for input or output to/from the prescribed file,
so specify the file name, and perform the input/output. When inputting,
take out file from the specified submemory, and input (call) in to the main
memory. When outputting, add the specified file name, and output
(register) it to the submemory.
2.1
INPUT/OUTPUT WITH
SUBMEMORY
2.1.1
System Parameter,
MTF, Setting Data
2.1.2
Family Program,
Material Data, Tooling
Information Sub Cycle
File

Leave a Reply

Your email address will not be published. Required fields are marked *