Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
2. INPUT/OUTPUT AND
COLLATION OF DATA
VARIOUS FILE AND DATA
221
NOTE
1 Submemory or memory cassettes are used for storage of
the family program, material file and tooling file, sub cycle
file. Use of the submemory or the memory cassette can be
designated with system parameter No.0015.
In both input and output devices, the initial value is 1 (sub
memory).
In general, the input/output device is selected by changing
the setting of parameter No.0015. However, it is also
possible to use the other device without changing the
parameter.
Instead of keying in 1 INPUT, key in 1, B INPUT to set
input/output with respect to the memory cassette, or key in
1, C INPUT to set input/output to the submemory. (When
, B or , C is omitted, the device set at parameter No.15
is applied.)
2 Each file name must be put when entering family program,
material data, tooling information or sub cycle file to
submemory.
The file name may be either numeric or alphanumeric, but
must be within 15character long.
3 You may have family program”, material data”, “tooling
information” and sub cycle file entered in a file area at the
same time.
If this case, however, it is impossible to mistake, for example
tooling file for family program. The same is true to the
procedure of memory cassette.
System parametre
0015
7
0
6
0
5
0
4 3
0
2
0
1
0
0
Input device
0: External
I/O device
1: File area
Output device
0: External I/O device
1: File area
(3)Replacing files
1) Key in the following when replacing the file registered on the sub
memory by the data on the main memory as described in (1):
1, R, @ file name “INPUT”
2) Then, the following question appears, meaning Is replacing
actually performed ?”:
REPLACE OK searched file name (1: OK 0: NO)
REP =
3) Key in
1
INPUT
and
0
INPUT
when performing replacement
with the searched file name or when not performing it for this
question, respectively.

Leave a Reply

Your email address will not be published. Required fields are marked *