Fanuc Symbol CAPi T Operators Manual

VARIOUS FILE AND DATA
B–63304EN/02
2. INPUT/OUTPUT AND
COLLATION OF DATA
222
It is possible to specify a file name in abbreviated from on
replacement.
Even if it is specified in abbreviated form, the actually replaced file
name becomes that searched.
Example 1)
Suppose there are two files within the sub memory, namely “ABC”
and “XYZ”. At this time, it is possible to specify either 1, R, @A or
1, R, @AB INPUT when performing replacement with the “ABC”
file.
If there are plural number of file names corresponding to the file name
(character string) keyed in on replacement, a message for “Perform
keying in again is output and no replacement processing is carried
out.
Example 2)
Suppose there are three files within the sub memory, namely “ABC”,
“A2”, and “XYZ”.
At this time, if the 1, R, @A “INPUT” is specified, the “perform
keying in again message is displayed and no replacement processing
is performed since there are two file names corresponding to A
(character string) and it is not possible to distinguish which was
specified.
Specify 1, R, @A2 “INPUT” in full name when performing
replacement of file, namely A2.
(4)Recording and reading family data automatically
With this function, family data can be retained when the power is
turned off while the user is programming. As a result, the user can
continue programming after turning on the power again.
Family data is a collection of data that makes up a family program.
The following data is recorded automatically as it is input during
programming:
Blank figure data Cutting condition data Material data
Part figure data Machining data Tooling information
C–axis figure data Yaxis figure data Process editing data etc.
When the power is turned on, the recorded family data is arranged in
order and restored. Note that, however, the family data is not read
when the power is turned on while one of the following keys is being
pressed:
1) When the power is turned on while the SP key is being pressed
2) When the power is turned on while the I key is being pressed
(In this case, all family data is cleared.)
3) When family data is not recorded correctly

Leave a Reply

Your email address will not be published. Required fields are marked *