Fanuc Symbol CAPi T Operators Manual

VARIOUS FILE AND DATA
B–63304EN/02
2. INPUT/OUTPUT AND
COLLATION OF DATA
232
(1)Method
1) When outputting data onto a floppy cassette it is normal to respond
to the question NO = by inputting a numeral followed by “B”
.
When naming a file, however, “F” should be entered in place of
“B”.
(Example)
In order to output a system parameter with a file name key in:
NO = 2, F
2) Responses to the following questions remain unchanged:
SET BC, AND KEY IN “OK” OR “NO”.
BC = OK <, INT OR ADD OR @ FILE NO.>
BC = (1:OK, 0:NO, I:INT, A:ADD)
3) Now specify file name
STANDARD FILE NAME: FAPT–SYS.PARAM.
KEY IN THE FILE NAME.
PRESS ‘INPUT’ KEY ONLY, IF YOU ACCEPT STANDARD
FILE NAME
FILE NAME = _
The following files names will first be displayed automatically
depending on the data to be output:
a) System parameter FAPT–SYS.PARAM.. . . . .
b) MTF FAPT–MTF. . . . . . . . . . . . . . .
c) Setting data FAPT–SETTING. . . . . . . . . .
d) Tool data FAPT–TOOL. . . . . . . . . . . .
e) Graphic data FAPT–GRAPHIC. . . . . . . . .
f) Family program FAPT–FAMILY. . . . . .
g) Material data FAPT–MATERIAL. . . . . . . . .
h) Sub cycle file FAPT–SUB.CYCLE. . . . . . . .
i) Tooling information FAPT–TOOLING. . .
If the standard file name is acceptable then press the “INPUT” key.
If you wish to register an alternative file name then specify your
preferred name up to a maximum of 17 characters.
“@” cannot be
used in a file name.
(2)Method of displaying file names
Refer to OPERATORS MANUAL for CNC 15T or 16T.
(3)File input
When reading in a file which has been output in this way the correct
response to the question BC = is to key in a numeral and then “B”
as before.
(4)Limitations
1) Two files with the same name cannot be registered on the same
cassette.
2) When specifying a file name:
a) If 18 or more characters are keyed in, only the first 17 characters
of the name specified will be registered as the file name.
b) If “@” is used for part or all of a file name then the error message
key in again will be displayed on the monitor screen.
Since File name = has not yet disappeared from the screen it
is still possible to specify and register a correct file name.
2.4
REGISTRATION OF
FILE NAME ONTO
FLOPPY CASSETTE,
HANDY FILE
(OPTION)

Leave a Reply

Your email address will not be published. Required fields are marked *