Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
2. INPUT/OUTPUT AND
COLLATION OF DATA
VARIOUS FILE AND DATA
233
Tooling information and material data can be punched out from the
external equipment in a specific format using ISO/EIA code. In addition,
data which is created on the computer beforehand can be read.
This function cannot be used for 5700 series of 16T CAPII.
NOTE
With the 16T CAP II, EIA code cannot be input/output.
(1)The file data input/output function is enabled only when bit 4 of
system parameter No.708 is on.
#7
708
#6 #5 #4 #3 #2 #1 #0
Bit 4 0 : Tooling information and material data are input/output in binary form
(conventional specification).
1: Tooling information and material data are input/output using the ISO
or EIA code (new specification).
(2)Whether the ISO code or EIA code is used depends on the setting in
system parameter No.1.
NOTE
In the 16T CAP II, the ISO code is always set for
input/output.
The conventional screen display for input/outout has not been changed.
If bit 4 of system parameter No.708 is 1, however, a comment is added
as follows:
Initial screen
=*= PARAMETER & DATA SET =*=
1. SYSTEM DATA SETTING & OUTPUT/INPUT
2. SETTING DATA CORRECTION
3. MATERIAL DATA CORRECTION
4. MATERIAL DATA OUTPUT
5. MATERIAL DATA INPUT
6. TOOLING INFORMATION CORRECTION
7. TOOLING INFORMATION OUTPUT
8. TOOLING INFORMATION INPUT
DATA
SET
For example, to punch material data on the external equipment, enter the
following in response to NO =”:
NO = 4, B (For the floppy cassette or handy file), or
NO = 4, P (for PPR or input/output equipment manufactured by
someone other than FANUC)
2.5
FILE DATA
INPUT/OUTPUT
FUNCTION
2.5.1
Parameter
2.5.2
Screen

Leave a Reply

Your email address will not be published. Required fields are marked *