Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
2. INPUT/OUTPUT AND
COLLATION OF DATA
VARIOUS FILE AND DATA
235
(2)Tooling information
Tooling information has the same format as tool data.
(3)Notes
NOTE
1 When undefined data is to be punched out, only its address
is output, and no data is output.
2 When data is read, all data on memory is replaced by the
new data.
3 If an invalid address is read during the data read operation,
no error occurs, and the address is ignored.
4 If the same address appears twice consecutively in the
same block when data is read, the second data is regarded
as valid.
If bit 4 of system parameter No.708 is on, the following standard file
names are used when file names are registered in the floppy cassette:
Material data MATERIAL. . . . . . . . . . .
Tooling information TOOLING. . . . .
2.5.4
File Name Registration
in the Floppy Cassette
or Handy File

Leave a Reply

Your email address will not be published. Required fields are marked *